The anti-crack mortar process is to use some kind of stainless steel tool to press the anti-crack mortar on the insulation board. And then lay the mesh cloth to overlap. Until the fiberglass cloth is completely hidden. It is a process of construction with special mortar. It can prevent cracks on the wall due to dry weather.

In daily life, when we pass by some construction sites, we will see many construction workers using anti-crack mortar for construction. So how did the anti-crack mortar construction process come from? What is the anti-crack mortar construction process?

Ⅰ. What is the anti-crack mortar construction process

1. The anti-crack mortar construction process is actually a mortar that can be used directly after adding water and stirring evenly after five minutes. The anti-crack mortar process does not require plastering or rolling the dust on the insulation board. The fiberglass mesh can be directly pressed into the mortar and mixed with warm water. In this way, the overlapping thickness is about ten centimeters, and the mortar must be completely buried.
Because the anti-crack mortar construction process is currently the most common construction process on the construction site, it is also deeply loved by everyone.
2. The anti-crack mortar process is to use some stainless steel tools to press the anti-crack mortar on the insulation board. Then lay the mesh cloth to overlap. Until the fiberglass cloth is completely hidden, it is a process of construction with special mortar. It can prevent cracks on the wall due to dry weather.

Ⅱ. Precautions for the construction process of anti-crack mortar

1. Although the anti-crack mortar construction process does not require the addition of any admixtures. However, the ratio between water and ash must be controlled. Once it is not well controlled. It is very likely that various quality problems will occur.

2. When we use the anti-crack mortar process, we must first apply some clean water on it. First moisten these base layers and then apply mortar to prevent cracking in the later stage.

3. When using the anti-crack mortar process. Be sure to pay attention to moisture-proof, rain-proof, and sun-proof, and place it in a warm, dry and ventilated place for ventilation.
Be sure to avoid getting it wet. During the process of the anti-crack mortar process, it must not be tempered too much, and the amount used during construction must be based on the area. If there is too much, it may cause agglomeration and quality problems. In addition, it should be noted that the construction temperature of the anti-cracking mortar should be below 5° and not too high.