The anti-cracking mortar process is to use some kind of stainless steel tool to press the anti-cracking mortar on the insulation board. Then spread the grid cloth to overlap. until the fiberglass cloth is completely hidden. It is a construction process with special mortar. It can prevent cracks on the wall surface due to the influence of dry weather.
In daily life, when we pass through some construction sites, we will see many construction workers using anti-cracking mortar for construction. So how did it construction process come about? What is the anti-crack mortar construction process?
Anti-cracking

1. What is the anti-cracking mortar construction technology

It construction process is actually directly adding water and stirring. A kind of mortar that can be used directly after stirring evenly after five minutes. It process does not require plastering or rolling dust on the insulation board. The fiberglass mesh can be pressed directly into the mortar and prepared with warm water. This overlapping thickness is about ten centimeters. The mortar must be fully embedded. Because it construction process is the most common construction process on the construction site at present, it is also deeply loved by everyone.
It process is to use some stainless steel tools to press the anti-cracking mortar on the insulation board. Then spread the grid cloth to overlap. until the fiberglass cloth is completely hidden. It is a construction process with special mortar. It can prevent cracks on the wall surface due to the influence of dry weather.

2. Matters needing attention in the construction process of anti-cracking mortar

Ⅰ. Although the anti-cracking mortar construction process does not need to add any admixtures. But be sure to control the ratio between water and ash. Once out of control. It is very likely that there will be various quality problems.
Ⅱ. When we use anti-cracking mortar technology. Be sure to smear some water on it first. Moisten these substrates before applying them with mortar. This prevents later cracking.
Ⅲ. When using anti-cracking mortar technology. Be sure to pay attention to moisture-proof, rain-proof and sun-proof. Put it in a warm, dry and ventilated place for ventilation. Be sure to keep it away from moisture. During the anti-cracking mortar process, it must not be tempered too much. The amount used during construction must be determined according to the area. If there is too much it may make it agglomerate. There is a quality problem. In addition, it should be noted that the construction temperature of the anti-cracking mortar should not be too high below 5°.
Anti-cracking
Landcel is a professional manufacturer of cellulose ether. The cellulose ether we produce is used as an additive for mortar. Can increase the ease of construction of mortar. Enhanced anti-sag and heat retention. If you need, you can contact us to get free samples.